Enterasys Networks D-Series - Manual (Page 336)

show cos state
11-20 Policy Classification Configuration
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable Class of Service:
D2(rw)->set cos state enable
show cos state
Use this command to display the Class of Service enable state.
Syntax
show cos state
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to show the Class of Service enable state:
D2(rw)->show cos state
Class-of-Service application is enabled
clear cos state
Use this command to set CoS state back to its default setting of disabled.
Syntax
clear cos state
Parameters
None.
enable | disable Enables or disables Class of Service on the switch. Default state is
disabled.