Enterasys Networks D-Series - Manual (Page 426)

set rmon channel
15-18 RMON Configuration
Example
This example shows how to display RMON channel information for fe.2.12:
D2(rw)->show rmon channel fe .2.12
Port fe .2.12 Channel index= 628 EntryStatus= valid
----------------------------------------------------------
Control off AcceptType matched
OnEventIndex 0 OffEventIndex 0
EventIndex 0 Status ready
Matches 4498
Description Thu Dec 16 12:57:32 EST 2004
Owner NetSight smith
set rmon channel
Use this command to configure an RMON channel entry.
Syntax
set rmon channel index port-string [accept {matched | failed}] [control {on | off}]
[description description] [owner owner]
Parameters
Defaults
If an action is not specified, packets will be accepted on filter matches.
If not specified, control will be set to off.
If a description is not specified, none will be applied.
If owner is not specified, it will be set to monitor.
Mode
Switch command, read‐write.
index Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
port‐string Specifies the port on which traffic will be monitored.
accept matched |
failed (Optional) Specifies the action of the filters on this channel as:
• matched ‐ Packets will be accepted on filter matches
• failed ‐ Packets will be accepted if they fail a match
control on | off (Optional) Enables or disables control of the flow of data through the
channel.
description
description (Optional) Specifies a description for this channel.
owner owner (Optional) Specifies the name of the entity that configured this entry.