Enterasys Networks D-Series - Manual (Page 169)

clear lacp static
Enterasys D-Series CLI Reference 6-43
Defaults
If not specified, a key will be assigned according to the specified aggregator. For example a key of 4
would be assigned to lag.0.4.
Mode
Switch command, read‐write.
Example
This example shows how to add port fe.1.6 to the LAG of aggregator port 6:
D2(su)->set lacp static lag.0.6 fe .1.6
clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove fe.1.6 from the LAG of aggregator port 6:
D2(su)->clear lacp static lag.0.6 fe .1.6
key (Optional) Specifies the new member port and LAG port aggregator
admin key value. Only ports with matching keys are allowed to
aggregate. Valid values are 0 ‐ 65535.
Note: This key value must be unique. If ports other than the desired
underlying physical ports share the same admin key value, aggregation
will fail or undesired aggregations will form.
port‐string Specifies the member port(s) to add to the LAG. For a detailed description
of possible port‐string values, refer to “
Port String Syntax Used in the CLI ”
on page 6‐1.
lagportstring Specifies the LAG aggregator port from which ports will be removed.
port‐string Specifies the port(s) to remove from the LAG. For a detailed description of
possible port‐string values, refer to “
Port String Syntax Used in the CLI ”
on page 6‐1.