Enterasys Networks D-Series - Manual (Page 70)

set boot system
2-32 Basic Configuration
set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the boot firmware image file to “newimage”:
D2(su)->set boot system newimage
Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The D‐Series switch
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
show telnet
Use this command to display the status of Telnet on the switch.
Syntax
show telnet
Parameters
None.
filename Specifies the name of the firmware image file.
For information about... Refer to page...
show telnet 2-32
set telnet 2-33
telnet 2-33