Set dhcp pool, Set dhcp pool -12 – Enterasys Networks D-Series User Manual
Page 444
set dhcp pool
16-12
DHCP Server Configuration
set dhcp pool
Use this command to create and assign a name to a DHCP server pool of addresses. Up to 16
address pools may be configured on a D‐Series. Note that entering this command is not required
to create an address pool before configuring other address pool parameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example creates an address pool named “auto1.”
D2(rw)->set dhcp pool auto1
set dhcp pool next-server
clear dhcp pool next-server
set dhcp pool lease
clear dhcp pool lease
set dhcp pool default-router
clear dhcp pool default-router
set dhcp pool dns-server
clear dhcp pool dns-server
set dhcp pool domain-name
clear dhcp pool domain-name
set dhcp pool netbios-name-server
clear dhcp pool netbios-name-server
set dhcp pool netbios-node-type
clear dhcp pool netbios-node-type
set dhcp pool option
clear dhcp pool option
show dhcp pool configuration
For information about...
Refer to page...
poolname
Specifies the name of the address pool. Pool names may be up to 31
characters in length.