Enterasys Networks D-Series - Manual (Page 489)

clear macauthentication portquietperiod
Enterasys D-Series CLI Reference 17-27
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets port 1 to wait 5 seconds after a failed authentication attempt before a new
attempt can be made:
D2(su)->set macauthentication portquietperiod 5 ge.1.1
clear macauthentication portquietperiod
This sets the quiet period back to the default value of 30 seconds.
Syntax
clear macauthentication portquietperiod [port-string]
Parameters
Defaults
If a port‐string is not specified then all ports will be set to the default port quiet period.
Mode
Switch command, read‐write.
Example
This example resets the default quiet period on port 1:
D2(su)->clear macauthentication portquietperiod ge.1.1
set macauthentication macinitialize
Use this command to force a current MAC authentication session to re‐initialize and remove the
session.
Syntax
set macauthentication macinitialize mac-addr
Parameters
port‐string (Optional) Specifies the ports for which the quiet period is to be reset. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
mac‐addr Specifies the MAC address of the session to re‐initialize.