Enterasys Networks D-Series - Manual (Page 344)

clear cos port-resource
11-28 Policy Classification Configuration
Group Index Resource Type Unit Rate Rate Limit Type Action
----------- -------- ---- ---- ---------- --------------- ------
2.0 1 irl kbps 10000 drop none
clear cos port-resource
Use this command to set the inbound rate limit in Kbps.
Syntax
clear cos port-resource irl {all | group-type-index [irl-index [unit] [rate]
[type]]}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the data rate to 0 for IRL resource index 1 for group 2.0.
D2(su)->clear cos port-resource irl 2.0 1 rate
set cos reference
Use this command to set the Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
irl Specifies that an IRL resource is to be cleared.
all Clear all IRL resources for all port groups.
group‐type‐index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
irl‐index (Optional) Inbound rate limiter resource index associated with the
specified port group. Valid values range from 0 to 99.
unit Clear the unit of measure for the inbound rate limiter.
rate Clear the data rate for this inbound rate limiter.
type Clear the action for the rate limiter.