Enterasys Networks D-Series - Manual (Page 264)

clear spantree lpcapablepartner
8-46 Spanning Tree Configuration
Defaults
If no port‐string is specified, Loop Protect capability for link partners is displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display the Loop Protect partner capability for fe.1.1:
D2(rw)->show spantree lpcapablepartner port fe .1.1
Link partner of port fe .1.1 is not LoopProtect-capable
clear spantree lpcapablepartner
Use this command to reset the Loop Protect capability of port link partners to the default state of
false.
Syntax
clear spantree lpcapablepartner port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the Loop Protect partner capability for fe.1.1:
D2(rw)->clear spantree lpcapablepartner fe .1.1
set spantree lpthreshold
Use this command to set the Loop Protect event threshold.
Syntax
set spantree lpthreshold value
Parameters
port‐string Specifies port(s) for which to clear their link partners’ Loop Protect
capability (reset to false).
value Specifies the number of events that must occur during the event
window in order to lock a port/SID. The default value is 3 events. A
threshold of 0 specifies that ports will never be locked.