Enterasys Networks D-Series - Manual (Page 154)

set linkflap downtime
6-28 Port Configuration
Parameters
Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap threshold on port fe.1.4 to 5.
D2(rw)->set linkflap threshold fe .1.4 5
set linkflap downtime
Use this command to set the time interval (in seconds) one or more ports will be held down after a
link flap violation.
Syntax
set linkflap downtime port-string downtime-value
Parameters
Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap downtime on port fe.1.4 to 5000 seconds.
D2(rw)->set linkflap downtime fe .1.4 5000
clear linkflap down
Use this command to toggle link flap disabled ports to operational.
Syntax
clear linkflap down [port-string]
port‐string Specifies the port(s) on which to set the link flap action trigger count.
threshold‐value Specifies the number of link down transitions necessary to trigger the
link flap action. A minimum of 1 must be configured.
port‐string Specifies the port(s) on which to set the link flap downtime.
downtime‐value Specifies a downtime in seconds. A value of 0 will set the downtime to
forever.