Enterasys Networks D-Series - Manual (Page 188)

Configuring SNMP Users, Groups, and Communities
7-8 SNMP Configuration
Configuring SNMP Users, Groups, and Communities
Purpose
To review and configure SNMP users, groups, and v1 and v2 communities. These are defined as
follows:
• User — A person registered in SNMPv3 to access SNMP management.
• Group — A collection of users who share the same SNMP access privileges.
• Community — A name used to authenticate SNMPv1 and v2 users.
Commands
show snmp user
Use this command to display information about SNMP users. These are people registered to
access SNMP management.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
If list is not specified, detailed SNMP information will be displayed.
For information about... Refer to page...
show snmp user 7-8
set snmp user 7-9
clear snmp user 7-10
show snmp group 7-11
set snmp group 7-12
clear snmp group 7-12
show snmp community 7-13
set snmp community 7-14
clear snmp community 7-14
list (Optional) Displays a list of registered SNMP user names.
user (Optional) Displays information about a specific user.
remote remote (Optional) Displays information about users on a specific remote SNMP
engine.
volatile | nonvolatile
| read‐only (Optional) Displays user information for a specified storage type.