Enterasys Networks D-Series - Manual (Page 318)

show policy profile
11-2 Policy Classification Configuration
Commands
show policy profile
Use this command to display policy profile information.
Syntax
show policy profile {all | profile-index [consecutive-pids] [-verbose]}
Parameters
Defaults
If optional parameters are not specified, summary information will be displayed for the specified
index or all indices.
Mode
Switch command, read‐only.
Example
This example shows how to display policy information for profile 11:
D2(su)->show policy profile 11
Profile Index : 11
Profile Name : MacAuth1
Row Status : active
Port VID Status : Enable
Port VID Override : 11
CoS : 0
CoS Status : Disable
Egress Vlans : none
Forbidden Vlans : none
Untagged Vlans : none
Rule Precedence : 1-31
:MACSource(1),MACDest(2),Unknown(3),
:Unknown(4),Unknown(5),Unknown(6),
:Unknown(7),Unknown(8),Unknown(9),
:Unknown(10),Unknown(11),IPSource(12),
Note: B3, C3, and G3 devices support profile-based CoS traffic rate limiting only. Policy rules
specifying CoS will only rate limit on D2, C2 and B2 devices, including when they are configured on
mixed stacks containing B3 and C3 devices.
For information about... Refer to page...
show policy profile 11-2
set policy profile 11-3
clear policy profile 11-4
all | profile‐index Displays policy information for all profile indexes or a specific profile index.
consecutive‐pids (Optional) Displays information for specified consecutive profile indexes.
‐verbose (Optional) Displays detailed information.