Enterasys Networks D-Series - Manual (Page 412)

set rmon stats
15-4 RMON Configuration
Multicast Pkts = 0 128 - 255 Octets = 0
CRC Errors = 0 256 - 511 Octets = 0
Undersize Pkts = 0 512 - 1023 Octets = 0
Oversize Pkts = 0 1024 - 1518 Octets = 0
Fragments = 0
Table 15‐40 provides an explanation of the command output.
set rmon stats
Use this command to configure an RMON statistics entry.
Syntax
set rmon stats index port-string [owner]
Parameters
Defaults
If owner is not specified, monitor will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to configure RMON statistics entry 2 for ge .1.20:
D2(rw)->set rmon stats 2 ge.1.20
clear rmon stats
Use this command to delete one or more RMON statistics entries.
Syntax
clear rmon stats {index-list | to-defaults}
Parameters
Defaults
None.
index Specifies an index for this statistics entry.
port‐string Specifies port(s) to which this entry will be assigned.
owner (Optional) Assigns an owner for this entry.
index‐list Specifies one or more stats entries to be deleted, causing them to disappear
from any future RMON queries.
to‐defaults Resets all history entries to default values. This will cause entries to
reappear in RMON queries.