Enterasys Networks D-Series - Manual (Page 380)

clear logging application
14-8 Logging and Network Management
Defaults
If level is not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to set the severity level for SNMP to 4 so that error conditions will be
logged for that application.
D2(rw)->set logging application SNMP level 4
clear logging application
Use this command to reset the logging severity level for one or all applications to the default value
of 6 (notifications of significant conditions).
Syntax
clear logging application {mnemonic | all}
level level (Optional) Specifies the severity level at which the server will log
messages for applications. Valid values and corresponding levels are:
1 — emergencies (system is unusable)
2 — alerts (immediate action required)
3 — critical conditions
4 — error conditions
5 — warning conditions
6 — notifications (significant conditions)
7 — informational messages
8 — debugging messages
Table 14-34 Mnemonic Values for Logging Applications
Mnemonic Application
CLIWEB Command Line Interface and Webview management
SNMP Simple Network Management Protocol
STP Spanning Tree Protocol
Driver Hardware drivers
System Non-application items such as general chassis management
Stacking Stacking management (if applicable)
UPN User Personalized Networking
Router Router