Enterasys Networks D-Series - Manual (Page 93)

Enterasys D-Series CLI Reference 4-1
4
Configuring System Power and PoE
The commands in this chapter allow you to review and set system power and PoE parameters,
including the power available to the system, the usage threshold for each module, whether or not
SNMP trap messages will be sent when power status changes, and per‐port PoE settings.
Commands
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Important Notice
Some commands in this section apply only to PoE-equipped D-Series devices. Consult the Installation Guide
shipped with your product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 4-1
set inlinepower threshold 4-2
set inlinepower trap 4-2
show port inlinepower 4-3
set port inlinepower 4-3