Enterasys Networks D-Series - Manual (Page 387)

disconnect
Enterasys D-Series CLI Reference 14-15
D2(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
Use this command to close an active console port or Telnet session from the switch CLI.
Syntax
disconnect {ip-addr | console}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
D2(su)->disconnect 134.141.192.119
This example shows how to close the current console session:
D2(su)->disconnect console
ip‐addr Specifies the IP address of the Telnet session to be disconnected. This
address is displayed in the output shown in “
show users ” on page 12‐15.
console Closes an active console port.