Enterasys Networks D-Series - Manual (Page 256)

clear spantree adminpathcost
8-38 Spanning Tree Configuration
Example
This example shows how to set the admin path cost to 200 for fe.3.2 on SID 1:
D2(su)->set spantree adminpathcost fe .3.2 200 sid 1
clear spantree adminpathcost
Use this command to reset the Spanning Tree default value for port admin path cost to 0.
Syntax
clear spantree adminpathcost port-string [sid sid]
Parameters
Defaults
If sid is not specified, admin path cost will be reset for Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to reset the admin path cost to 0 for fe.3.2 on SID 1:
D2(su)->clear spantree adminpathcost fe .3.2 sid 1
show spantree adminedge
Use this command to display the edge port administrative status for a port.
Syntax
show spantree adminedge [port port-string]
Parameters
Defaults
If port‐string is not specified edge port administrative status will be displayed for all Spanning Tree
ports.
port‐string Specifies the port(s) for which to reset admin path cost. For a detailed
description of possible port‐string values, refer to “
Port String Syntax
Used in the CLI ” on page 6‐1.
sid sid (Optional) Resets the admin path cost for specific Spanning Tree(s).
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
port‐string (Optional) Displays edge port administrative status for specific
port(s). For a detailed description of possible port‐string values,
refer to “
Port String Syntax Used in the CLI ” on page 6‐1.