Enterasys Networks D-Series - Manual (Page 62)

set system location
2-24 Basic Configuration
Defaults
If string is not specified, the system name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system name to Information Systems:
D2(su)->set system name “Information Systems”
set system location
Use this command to identify the location of the system.
Syntax
set system location [string]
Parameters
Defaults
If string is not specified, the location name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system location string:
D2(su)->set system location “Bldg N32-04 Closet 9”
set system contact
Use this command to identify a contact person for the system.
Syntax
set system contact [string]
string (Optional) Specifies a text string that indicates where the system is
located.
Note: A location string containing a space in the text must be
enclosed in quotes as shown in the example below.