Enterasys Networks D-Series - Manual (Page 61)

set system name
Enterasys D-Series CLI Reference 2-23
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display version information. Please note that you may see different
information displayed, depending on the type of hardware.
D2(su)->show version
Copyright (c) 2008 by Enterasys Networks, Inc.
Model Serial # Versions
-------------- ----------------- -------------------
D2G124-12P 001188021035 Hw:BCM5665 REV 17
Bp:01.00.29
Fw: 1.0.xx BuFw:03.01.13
Table 2‐5 provides an explanation of the command output.
set system name
Use this command to configure a name for the system.
Syntax
set system name [string]
Parameters
Table 2-5 show version Output Details
Output Field What It Displays...
Model Switch’s model number.
Serial # Serial number of the switch.
Versions • Hw: Hardware version number.
• Bp: BootPROM version.
• Fw: Current firmware version number.
• BuFw: Backup firmware version number.
string (Optional) Specifies a text string that identifies the system.
Note: A name string containing a space in the text must be enclosed in
quotes as shown in the example below.