Enterasys Networks D-Series - Manual (Page 137)

set port speed
Enterasys D-Series CLI Reference 6-11
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto‐negotiation disabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set fe.3.3 to a port speed of 10 Mbps:
D2(su)->set port speed fe .3.3 10
show port duplex
Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [port-string]
Parameters
Defaults
If port‐string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, read‐only.
port‐string Specifies the port(s) for which to a speed value will be set. For a
detailed description of possible port‐string values, refer to “
Port
String Syntax Used in the CLI ” on page 6‐1.
10 | 100 | 1000 Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.
port‐string (Optional) Displays default duplex setting(s) for specific port(s).
For a detailed description of possible port‐string values, refer to
“
Port String Syntax Used in the CLI ” on page 6‐1.