Enterasys Networks D-Series - Manual (Page 479)

show eapol
Enterasys D-Series CLI Reference 17-17
This example shows how to reset the 802.1X quiet period to 60 seconds on ports fe.1.1‐3:
D2(su)->clear dot1x auth-config quietperiod fe .1.1-3
show eapol
Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports fe.1.1‐3:
D2(su)->show eapol fe .1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
fe .1.1 Initialize Auto
fe .1.2 Initialize Auto
fe .1.3 Initialize Auto
Table 17‐43 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to “ set eapol ” on
page 17‐19.
port‐string (Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 6‐1.