Enterasys Networks D-Series - Manual (Page 265)

show spantree lpthreshold
Enterasys D-Series CLI Reference 8-47
Defaults
None. The default event threshold is 3.
Mode
Switch command, read‐write.
Usage
The LoopProtect event threshold is a global integer variable that provides protection in the case of
intermittent failures. The default value is 3. If the event counter reaches the threshold within a
given period (the event window), then the port, for the given SID, becomes locked (that is, held
indefinitely in the blocking state). If the threshold is 0, the ports are never locked.
Example
This example shows how to set the Loop Protect threshold value to 4:
D2(rw)->set spantree lpthreshold 4
show spantree lpthreshold
Use this command to display the current value of the Loop Protect event threshold.
Syntax
show spantree lpthreshold
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current Loop Protect threshold value:
D2(rw)->show spantree lpthreshold
The Loop Protect event threshold value is 4
clear spantree lpthreshold
Use this command to return the Loop Protect event threshold to its default value of 3.
Syntax
clear spantree lpthreshold
Parameters
None.