Enterasys Networks D-Series - Manual (Page 144)

clear port advertise
6-18 Port Configuration
Mode
Switch command, read‐write.
Example
This example shows how to configure port 1 to advertise 1000BASE‐T full duplex:
D2(su)->set port advertise ge.1.1 1000tfd
clear port advertise
Use this command to configure a port to not advertise a specific speed/duplex capability when
auto‐negotiating with another port.
Syntax
clear port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to configure port 1 to not advertise 10 MB capability for auto‐
negotiation:
D2(su)->clear port advertise ge.1.1 10t 10tfd
port‐string Clear advertisements for specific port(s). For a detailed description of
possible port‐string values, refer to “
Port String Syntax Used in the
CLI ” on page 6‐1.
10t Do not advertise 10BASE‐T half duplex mode.
10tfd Do not advertise 10BASE‐T full duplex mode.
100tx Do not advertise 100BASE‐TX half duplex mode.
100txfd Do not advertise 100BASE‐TX full duplex mode.
1000t Do not advertise 1000BASE‐T half duplex mode.
1000tfd Do not advertise 1000BASE‐T full duplex mode.
pause Do not advertise PAUSE for full‐duplex links.