Enterasys Networks D-Series - Manual (Page 161)

clear port mirroring
Enterasys D-Series CLI Reference 6-35
Usage
Note that LAG ports and their underlying physical ports, as described in “ Link Aggregation
Control Protocol (LACP) ” on page 6‐36, cannot be mirrored.
Example
This example shows how to create and enable port mirroring with fe.1.4 as the source port, and
fe.1.11 as the target port:
D2(su)->set port mirroring create fe .1.4 fe .1.11
D2(su)->set port mirroring enable fe .1.4 fe .1.11
clear port mirroring
Use this command to clear a port mirroring relationship.
Syntax
clear port mirroring source destination
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear port mirroring between source port fe.1.4 and target port fe.1.11:
D2(su)->clear port mirroring fe .1.4 fe .1.11
source Specifies the source port of the mirroring configuration to be cleared. For
a detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
destination Specifies the target port of the mirroring configuration to be cleared.