Enterasys Networks D-Series - Manual (Page 241)

show spantree tctrapsuppress
Enterasys D-Series CLI Reference 8-23
Example
This example shows how to reset the backup root function to disabled on SID 2:
D2(rw)->clear spantree backuproot 2
show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the status of topology change trap suppression:
D2(rw)->show spantree tctrapsuppress
Topology change Trap Suppression is set to enabled
set spantree tctrapsuppress
Use this command to disable or enable topology change trap suppression on Rapid Spanning Tree
edge ports.
Syntax
set spantree tctrapsuppress {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
disable | enable Disables or enables topology change trap suppression.