Enterasys Networks D-Series - Manual (Page 130)

show port
6-4 Port Configuration
show port
Use this command to display whether or not one or more ports are enabled for switching.
Syntax
show port [port-string]
Parameters
Defaults
If port‐string is not specified, operational status information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display operational status information for fe.3.14:
D2(su)->show port fe .3.14
Port fe .3.14 enabled
show port status
Use this command to display operating and admin status, speed, duplex mode and port type for
one or more ports on the device.
Syntax
show port status [port-string]
Parameters
Defaults
If port‐string is not specified, status information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display status information for fe.3.14:
D2(su)->show port status fe .3.14
Port Alias Oper Admin Speed Duplex Type
port‐string (Optional) Displays operational status for specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 6‐1.
port‐string (Optional) Displays status for specific port(s). For a detailed description of
possible port‐string values, refer to “
Port String Syntax Used in the CLI ” on
page 6‐1.