Enterasys Networks D-Series - Manual (Page 86)

set webview
2-48 Basic Configuration
set webview
Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
It is good practice for security reasons to disable HTTP access on the switch when finished
configuring with WebView, and then to only enable WebView on the switch when changes need to
be made.
Example
This example shows how to disable WebView on the switch:
D2(rw)->set webview disable
show ssl
Use this command to display SSL status.
Syntax
show ssl
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display SSL status:
D2(rw)->show ssl
SSL status: Enabled
enable | disable Enable or disable WebView on the switch.