Enterasys Networks D-Series - Manual (Page 374)

show logging server
14-2 Logging and Network Management
show logging server
Use this command to display the Syslog configuration for a particular server.
Syntax
show logging server [index]
Parameters
Defaults
If index is not specified, all Syslog server information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display Syslog server configuration information:
D2(ro)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5) default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
Table 14‐32 provides an explanation of the command output.
clear logging application 14-8
show logging local 14-9
set logging local 14-9
clear logging local 14-10
show logging buffer 14-10
For information about... Refer to page...
index (Optional) Displays Syslog information pertaining to a specific server
table entry. Valid values are 1‐8.
Table 14-32 show logging server Output Details
Output Field What It Displays...
IP Address Syslog server’s IP address. For details on setting this using the set logging server
command, refer to “
set logging server ” on page 14-3.
Facility Syslog facility that will be encoded in messages sent to this server. Valid values are:
local0 to local7.
Severity Severity level at which the server is logging messages.
Description Text string description of this facility/server.
Port UDP port the client uses to send to the server.
Status Whether or not this Syslog configuration is currently enabled or disabled.