Enterasys Networks D-Series - Manual (Page 125)

clear lldp port tx-tlv
Enterasys D-Series CLI Reference 5-29
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example returns port ge .1.1 to the default LLDP‐MED trap state of disabled.
D2(rw)->clear lldp port med-trap ge.1.1
clear lldp port tx-tlv
Use this command to clear the optional LLDP and LLDP‐MED TLVs to be transmitted in
LLDPDUs by the specified port or ports to the default value of disabled.
Syntax
clear lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-loc] [med-poe]} port-string
Parameters
port‐string Specifies the port or range of ports to be affected.
all Disables all optional TLVs from being transmitted in LLDPDUs.
port‐desc Disables the Port Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys‐name Disables the System Name optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys‐desc Disables the System Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys‐cap Disables the System Capabilities optional basic LLDP TLV from
being transmitted in LLDPDUs.
mgmt‐addr Disables the Management Address optional basic LLDP TLV from
being transmitted in LLDPDUs.
vlan‐id Disables the Port VLAN ID IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
stp Disables the Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV from being transmitted in LLDPDUs.
lacp Disables the LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
gvrp Disables the GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
mac‐phy Disables the MAC‐PHY Configuration/Status IEEE 802.3 Extensions
TLV from being transmitted in LLDPDUs.