Enterasys Networks D-Series - Manual (Page 57)

set summertime recurring
Enterasys D-Series CLI Reference 2-19
Defaults
If an offset is not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to set a daylight savings time start date of April 4, 2004 at 2 a.m. and an
ending date of October 31, 2004 at 2 a.m. with an offset time of one hour:
D2(su)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60
set summertime recurring
Use this command to configure recurring daylight savings time settings. These settings will start
and stop daylight savings time at the specified day of the month and hour each year and will not
have to be reset annually.
Syntax
set summertime recurring start_week start_day start_month start_hr_min end_week
end_day end_month end_hr_min [offset_minutes]
Parameters
start_year Specifies the year to start daylight savings time.
start_hr_min Specifies the time of day to start daylight savings time. Format is hh:mm.
end_month Specifies the month of the year to end daylight savings time.
end_date Specifies the day of the month to end daylight savings time.
end_year Specifies the year to end daylight savings time.
end_hr_min Specifies the time of day to end daylight savings time. Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.
start_week Specifies the week of the month to restart daylight savings time. Valid
values are: first, second, third, fourth, and last.
start_day Specifies the day of the week to restart daylight savings time.
start_hr_min Specifies the time of day to restart daylight savings time. Format is
hh:mm.
end_week Specifies the week of the month to end daylight savings time.
end_day Specifies the day of the week to end daylight savings time.
end_hr_min Specifies the time of day to end daylight savings time. Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.