Enterasys Networks D-Series - Manual (Page 415)

set rmon history
Enterasys D-Series CLI Reference 15-7
Sample 2779 Interval Start: 1 days 0 hours 2 minutes 22 seconds
Drop Events = 0 Undersize Pkts = 0
Octets = 0 Oversize Pkts = 0
Packets = 0 Fragments = 0
Broadcast Pkts = 0 Jabbers = 0
Multicast Pkts = 0 Collisions = 0
CRC Align Errors = 0 Utilization(%) = 0
set rmon history
Use this command to configure an RMON history entry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
Defaults
If buckets is not specified, the maximum number of entries maintained will be 50.
If not specified, interval will be set to 30 seconds.
If owner is not specified, monitor will be applied.
Mode
Switch command, read‐write.
Example
This example shows how configure RMON history entry 1 on port fe.2.1 to sample every 20
seconds:
D2(rw)->set rmon history 1 fe .2.1 interval 20
clear rmon history
Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to “
set rmon history ” on page 15‐7.
Syntax
clear rmon history {index-list | to-defaults}
index‐list Specifies an index number for this entry.
port‐string (Optional) Assigns this entry to a specific port.
buckets buckets (Optional) Specifies the maximum number of entries to maintain.
interval interval (Optional) Specifies the sampling interval in seconds.
owner owner (Optional) Specifies an owner for this entry.