Enterasys Networks D-Series - Manual (Page 90)

show license
3-2 Activating Licensed Features
Usage
When you execute the set license command, you will be prompted to accept the license
agreement. If you do not accept the license agreement, the licensed feature will not be enabled.
Example
This example shows how to activate a license on a D‐Series switch.
D2(rw)->set license D2Policy
Terms of this license may be found at
http://www.enterasys.com/support/fla.aspx
Do you accept the terms of the applicable policy license (y/n) [n]?y
License successfully enabled
show license
Use this command to display license key information for switches with activated licenses.
Syntax
show license
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
Licenses can be displayed, applied, and cleared only with the license commands described in this
chapter. General configuration commands such as show config or clear config do not affect
licenses.
Example
This example shows how to display license key information.
D2(ro)->show license
D2Policy: status Active
clear license
Use this command to clear the license settings.
Syntax
clear license featureId feature