Show lldp port remote-info output display -21, Example – Enterasys Networks D-Series User Manual

Page 117

show lldp port remote-info

Enterasys D-Series CLI Reference

5-21

Example

This example shows how to display the remote system information stored for port

.3.1. The

remote system information was received from an IP phone, which is an LLDP‐MED‐enabled
device.

Table 5‐5

describes the output fields that are unique to the remote system information

displayed for a MED‐enabled device.

D2(ro)->show lldp port remote-info ge.3.1

Local Port : ge.3.1 Remote Port Id : 00-09-6e-0e-14-3d

---------------------

Mgmt Addr : 0.0.0.0

Chassis ID : 0.0.0.0

Device Type : Communication Device Endpoint (class III)

Sys Name : AVE0E143D

Sys Cap Supported/Enabled : bridge,telephone/bridge

Auto-Neg Supported/Enabled : yes/yes

Auto-Neg Advertised : 10BASE-T, 10BASE-TFD

: 100BASE-TX, 100BASE-TXFD

: pause, Spause

Operational Speed/Duplex/Type : 100/full/TX

Hardware Revision : 4610D01A

Firmware Revision : b10d01b2_7.bin

Software Revision : a10d01b2_7.bin

Serial Number : 05GM42004348

Manufacturer : Avaya

Model Number : 4610

Note that the information fields displayed by the show lldp port remote‐info command will vary,
depending on the type of remote device that is connected to the port.

Table 5‐5

describes the output fields that are unique to the remote system information database.

Refer to Table 5‐4 on page 19 for descriptions of the information fields that are common to both the
local and the remote system information databases.

Table 5-5

show lldp port remote-info Output Display

Output Field

What it Displays...

Remote Port Id

Displays whatever port Id information received in the LLDPDU from the remote
device. In this case, the port Id is MAC address of remote device.

Device Type

Mandatory LLDP-MED Capabilities TLV. Displayed only when the port is
connected to an LLDP-MED-capable endpoint device.

Hardware Revision