Enterasys Networks D-Series User Manual
Page 207
set snmp targetaddr
Enterasys D-Series CLI Reference
7-27
Parameters
Defaults
If not specified, udpport will be set to 162.
If not specified, mask will be set to 255.255.255.255
If not specified, timeout will be set to 1500.
If not specified, number of retries will be set to 3.
If taglist is not specified, none will be set.
If not specified, storage type will be nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to configure a trap notification called “TrapSink.” This trap notification
will be sent to the workstation 192.168.190.80 (which is target address “tr”). It will use security
and authorization criteria contained in a target parameters entry called “v2cExampleParams”. For
more information on configuring a basic SNMP trap, refer to “
D2(su)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams taglist
TrapSink
targetaddr
Specifies a unique identifier to index the snmpTargetAddrTable.
Maximum length is 32 bytes.
ipaddr
Specifies the IP address of the target.
param param
Specifies an entry in the SNMP target parameters table, which is used
when generating a message to the target. Maximum length is 32 bytes.
udpport udpport
(Optional) Specifies which UDP port of the target host to use.
mask mask
(Optional) Specifies the IP mask of the target.
timeout timeout
(Optional) Specifies the maximum round trip time allowed to
communicate to this target address. This value is in .01 seconds and the
default is 1500 (15 seconds.)
retries retries
(Optional) Specifies the number of message retries allowed if a response is
not received. Default is 3.
taglist taglist
(Optional) Specifies a list of SNMP notify tag values. This tags a location
to the target address as a place to send notifications. List must be enclosed
in quotes and tag values must be separated by a space (for example,
“tag 1 tag 2”).
volatile |
nonvolatile
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.