Enterasys Networks D-Series - Manual (Page 466)

show radius
17-4 Security Configuration
show radius
Use this command to display the current RADIUS client/server configuration.
Syntax
show radius [status | retries | timeout | server [index | all]]
Parameters
Defaults
If no parameters are specified, all RADIUS configuration information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RADIUS configuration information:
D2(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS Server IP Address Auth-Port Realm-Type
-------------- ---------- --------- -----------------
10 172.16.20.10 1812 management-access
Table 17‐42 provides an explanation of the command output.
set radius accounting 17-8
clear radius accounting 17-9
For information about... Refer to page...
status (Optional) Displays the RADIUS server’s enable status.
retries (Optional) Displays the number of retry attempts before the RADIUS server
times out.
timeout (Optional) Displays the maximum amount of time (in seconds) to establish
contact with the RADIUS server before retry attempts begin.
server (Optional) Displays RADIUS server configuration information.
index | all For use with the server parameter to show server configuration for all
servers or a specific RADIUS server as defined by an index.
Table 17-42 show radius Output Details
Output Field What It Displays...
RADIUS status Whether RADIUS is enabled or disabled.
RADIUS retries Number of retry attempts before the RADIUS server times out. The default value of 3
can be reset using the set radius command as described in “
set radius ” on
page 17-5.