Enterasys Networks D-Series - Manual (Page 94)

set inlinepower threshold
4-2 Configuring System Power and PoE
Example
This example shows how to display system power properties:
D2(su)->show inlinepower
Detection Mode : auto
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
1 auto 480 0.00 0.00 80 enable
set inlinepower threshold
Use this command to set the power usage thresholdon a specified unit or module.
Syntax
set inlinepower threshold usage-threshold unit-number
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the power threshold to 50 on module/unit 1:
D2(su)->set inlinepower threshold 50 1
set inlinepower trap
Use this command to enable or disable the sending of an SNMP trap message for a unit or module
whenever the status of its ports changes, or whenever the unit’s power usage threshold is crossed.
The unit’s power usage threshold must be set using the set inlinepower threshold command as
described on page
4‐2 .
Syntax
set inlinepower trap {disable | enable}
Parameters
Mode
Switch command, read‐write.
usage‐threshold Specifies a power threshold as a percentage of total system power usage.
Valid values are 11 to 100.
disable | enable Disables or enables inline power trap messaging.