Enterasys Networks D-Series - Manual (Page 234)

set spantree mstcfgid
8-16 Spanning Tree Configuration
MAC address) have not been changed. For information on using the set spantree mstcfgid
command to change these settings, refer to “
set spantree mstcfgid ” on page 8‐16:
D2(su)->show spantree mstcfgid
MST Configuration Identifier:
Format Selector: 0
Configuration Name: 00:01:f4:89:51:94
Revision Level: 0
Configuration Digest: ac:36:17:7f:50:28:3c:d4:b8:38:21:d8:ab:26:de:62
set spantree mstcfgid
Use this command to set the MST configuration name and/or revision level.
Syntax
set spantree mstcfgid {cfgname name | rev level}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the MST configuration name to “mstconfig”:
D2(su)->set spantree mstconfigid cfgname mstconfig
clear spantree mstcfgid
Use this command to reset the MST revision level to a default value of 0, and the configuration
name to a default string representing the bridge MAC address.
Syntax
clear spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
cfgname name Specifies an MST configuration name.
rev level Specifies an MST revision level. Valid values are 0 ‐ 65535.