Enterasys Networks D-Series - Manual (Page 166)

set lacp
6-40 Port Configuration
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
Syntax
set lacp {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable LACP:
D2(su)->set lacp disable
Table 6-11 show lacp Output Details
Output Field What It Displays...
Global Link
Aggregation state Shows if LACP is enabled or disabled on the switch.
Single Port LAGs Displays if the single port LAG feature has been enabled on the switch. See “ set lacp
singleportlag ” on page 6-44 for more about single port LAG.
Aggregator LAG port designation. Each D-Series module provides 6 virtual link aggregator ports,
which are designated in the CLI as lag.0.1 through lag.0.6. Once underlying physical
ports (for example,
fe .x.x) are associated with an aggregator port, the resulting Link
Aggregation Group (LAG) is represented with a lag.x.x port designation.
Actor Local device participating in LACP negotiation.
Partner Remote device participating in LACP negotiation.
System Identifier MAC addresses for actor and partner.
System Priority System priority value which determines aggregation precedence. Only one LACP
system priority can be set on a D-Series device, using either the set lacp asyspri
command (
page 6-41 ), or the set port lacp command ( page 6-46 ) .
Admin Key Port’s assigned key. D-Series devices provide a default admin key value of 32768 for
all LAG ports (lag.0.1 though lag.0.6).
Oper Key Port’s operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator’s will be allowed to aggregate.
Attached Ports Underlying physical ports associated with this aggregator.
disable | enable Disables or enables LACP.