Enterasys Networks D-Series - Manual (Page 190)

clear snmp user
7-10 SNMP Configuration
Parameters
Defaults
If remote is not specified, the user will be registered for the local SNMP engine.
If authentication is not specified, no authentication will be applied.
If privacy is not specified, no encryption will be applied.
If storage type is not specified, nonvolatile will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to create a new SNMP user named “netops”. By default, this user will be
registered on the local SNMP engine without authentication
and encryption. Entries related to this
user will be stored in permanent (nonvolatile) memory:
D2(su)->set snmp user netops
clear snmp user
Use this command to remove a user from the SNMPv3 security‐model list.
Syntax
clear snmp user user [remote remote]
Parameters
Defaults
If remote is not specified, the user will be removed from the local SNMP engine.
Mode
Switch command, read‐write.
user Specifies a name for the SNMPv3 user.
remote remoteid (Optional) Registers the user on a specific remote SNMP engine.
authentication md5
| sha (Optional) Specifies the authentication type required for this user as MD5
or SHA.
authpassword (Optional) Specifies a password for this user when authentication is
required. Minimum of 8 characters.
privacy privpassword (Optional) Applies encryption and specifies an encryption password.
Minimum of 8 characters.
volatile |
nonvolatile (Optional) Specifies a storage type for this user entry.
user Specifies an SNMPv3 user to remove.
remote remote (Optional) Removes the user from a specific remote SNMP engine.