Enterasys Networks D-Series - Manual (Page 87)

set ssl
Enterasys D-Series CLI Reference 2-49
set ssl
Use this command to enable or disable the use of WebView over SSL port 443. By default, SSL is
disabled on the switch. This command can also be used to reinitialize the hostkey that is used for
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable SSL:
D2(rw)->set ssl enabled
enabled | disabled Enable or disable the ability to use WebView over SSL.
reinitialize Stops and then restarts the SSL process.
hostkey reinitialize Stops SSL, regenerates new keys, and then restarts SSL.