Enterasys Networks D-Series - Manual (Page 48)

show ip address
2-10 Basic Configuration
show ip address
Use this command to display the system IP address and subnet mask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the system IP address and subnet mask:
D2(su)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20 255.255.0.0
set ip address
Use this command to set the system IP address, subnet mask and default gateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
Parameters
Defaults
If not specified, ip‐mask will be set to the natural mask of the ip‐address and ip‐gateway will be set to
the ip‐address.
show console 2-27
set console baud 2-28
For information about... Refer to page...
Note: The D2 does not support the ability for a user to configure the host's gateway to be a local
routed interface IP. The host's gateway must exist on a different device in the network if one is
configured.
ip‐address Sets the IP address for the system. .
mask ip‐mask (Optional) Sets the system’s subnet mask.
gateway ip‐gateway (Optional) Sets the system’s default gateway (next‐hop device).