Enterasys Networks D-Series - Manual (Page 246)

clear spantree spanguardtimeout
8-28 Spanning Tree Configuration
clear spantree spanguardtimeout
Use this command to reset the Spanning Tree SpanGuard timeout to the default value of 300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard timeout to 300 seconds:
D2(rw)->clear spantree spanguardtimeout
show spantree spanguardlock
Use this command to display the SpanGuard lock status of one or more ports.
Syntax
show spantree spanguardlock [port-string]
Parameters
Defaults
If no port string is specified, the SpanGuard lock status for all ports is displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard lock status for ge .1.1:
D2(su)->show spantree spanguardlock ge.1.1
Port ge.1.1 is Unlocked
port‐string (Optional) Specifies the port(s) for which to show SpanGuard lock status.
For a detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.