Enterasys Networks D-Series - Manual (Page 73)

show snmp persistmode
Enterasys D-Series CLI Reference 2-35
Commands
show snmp persistmode
Use this command to display the configuration persistence mode setting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
By default, the mode is set to “auto save,” which automatically saves configuration changes at
specific intervals. If the mode is set to “manual,” configuration commands are never automatically
saved. In order to make configuration changes persistent when the mode is manual, the save
config command must be issued as described in “
Configuration Persistence Mode ” on page 2‐34.
For information about... Refer to page...
show snmp persistmode 2-35
set snmp persistmode 2-36
save config 2-36
dir 2-37
show file 2-38
show config 2-38
configure 2-39
copy 2-40
delete 2-41
show tftp settings 2-41
set tftp timeout 2-42
clear tftp timeout 2-42
set tftp retry 2-43
clear tftp retry 2-43