Enterasys Networks D-Series - Manual (Page 254)

clear spantree portpri
8-36 Spanning Tree Configuration
Parameters
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to set the priority of fe.1.3 to 240 on SID 1
D2(su)->set spantree portpri fe .1.3 240 sid 1
clear spantree portpri
Use this command to reset the bridge priority of a Spanning Tree port to a default value of 128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to reset the priority of fe.1.3 to 128 on SID 1
D2(su)->clear spantree portpri fe .1.3 sid 1
port‐string Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
priority Specifies a number that represents the priority of a link in a Spanning Tree
bridge. Valid values are from 0 to 240 (in increments of 16) with 0
indicating high priority.
sid sid (Optional) Sets port priority for a specific Spanning Tree identifier. Valid
values are 0 ‐ 4094. If not specified, SID 0 is assumed.
port‐string Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
sid sid (Optional) Resets the port priority for a specific Spanning Tree identifier.
Valid values are 0 ‐ 4094. If not specified, SID 0 will be assumed.