Enterasys Networks D-Series - Manual (Page 402)

set sntp poll-interval
14-30 Logging and Network Management
Mode
Switch command, read‐write.
Example
This example shows how to remove the server at IP address 10.21.1.100 from the SNTP server list:
D2(su)->clear sntp server 10.21.1.100
set sntp poll-interval
Use this command to set the poll interval between SNTP unicast requests.
Syntax
set sntp poll-interval interval
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the SNTP poll interval to 30 seconds:
D2(su)->set sntp poll-interval 30
clear sntp poll-interval
Use this command to clear the poll interval between unicast SNTP requests.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
interval Specifies the poll interval in seconds. Valid values are 16 to 16284.