Enterasys Networks D-Series - Manual (Page 151)

set linkflap globalstate
Enterasys D-Series CLI Reference 6-25
set linkflap globalstate
Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
Defaults
By default, the function is disabled globally and on all ports.
Mode
Switch mode, read‐write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per‐port
settings have been configured using the linkflap commands, per‐port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
D2(rw)->set linkflap globalstate enable
set linkflap portstate
Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
Defaults
If port‐string is not specified, all ports are enabled or disabled.
TimeElapsed Time (in seconds) since the last link down event.
Violations Number of link flap violations on listed ports since system start.
Table 6-9 show linkflap metrics Output Details (Continued)
Output Field What it displays...
disable | enable Globally disables or enables the link flap detection function.
disable | enable Disables or enables the link flap detection function.
port‐string (Optional) Specifies the port or ports on which to disable or enable
monitoring.