Enterasys Networks D-Series - Manual (Page 199)

Configuring SNMP MIB Views
Enterasys D-Series CLI Reference 7-19
Example
This example shows how to clear SNMP version 3 access for the “mis‐group” via the
authentication protocol:
D2(su)->clear snmp access mis-group security-model usm authentication
Configuring SNMP MIB Views
Purpose
To review and configure SNMP MIB views. SNMP views map SNMP objects to access rights.
Commands
show snmp view
Use this command to display the MIB configuration for SNMPv3 view‐based access (VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
Defaults
If no parameters are specified, all SNMP MIB view configuration information will be displayed.
Mode
Switch command, read‐only.
For information about... Refer to page...
show snmp view 7-19
show snmp context 7-20
set snmp view 7-21
clear snmp view 7-22
viewname (Optional) Displays information for a specific MIB view.
subtree oid‐or‐mibobject (Optional) Displays information for a specific MIB subtree when
viewname is specified.
volatile | nonvolatile |
read‐only (Optional) Displays entries for a specific storage type.