Enterasys Networks D-Series - Manual (Page 129)

Reviewing Port Status
Enterasys D-Series CLI Reference 6-3
Example
This example shows how to configure port ge.2.1 in the D2G124‐12 to operate with a 100BASE‐FX
transceiver installed. First, the port status is shown as operating as a 1000BASE‐SX port. After the
1‐Gigabit transceiver is replaced with the a 100 Mbps transceiver, the port is configured
appropriately and the new settings are verified.
D2(su)->show port advertise ge.2.1
ge.2.1 capability advertised remote
-------------------------------------------------
10BASE-T no no no
10BASE-TFD no no no
100BASE-TX no no no
100BASE-TXFD yes no no
1000BASE-T no no no
1000BASE-TFD yes yes no
pause yes yes no
D2(su)->show port status ge.2.1
Alias Oper Admin Speed
Port (truncated) Status Status (bps) Duplex Type
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1 Down Up N/A N/A 1000BASE-SX
D2(su)->set port negotiation ge.2.1 disable
D2(su)->set port advertise ge.2.1 100txfd
D2(su)->set port speed ge.2.1 100
D2(su)->set port duplex ge.2.1 full
D2(su)->show port status ge.2.1
Alias Oper Admin Speed
Port (truncated) Status Status (bps) Duplex Type
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1 Down Up 100.0M full 100BASE-FX
For more information, refer to the commands in this chapter and to your D‐Series hardware
installation documentation.
Reviewing Port Status
Purpose
To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.
Commands
For information about... Refer to page...
show port 6-4
show port status 6-4
show port counters 6-5