Enterasys Networks D-Series - Manual (Page 351)

clear port priority
Enterasys D-Series CLI Reference 12-3
Syntax
set port priority port-string priority
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
The set port priority command will not change the 802.1p priority tag on tagged traffic with a
default priority tag. The command only has an effect on how untagged traffic will be prioritized
as it passes internally through the device.
Example
This example shows how to set a default priority of 6 on fe.1.3. Frames received by this port
without priority information in their frame header are set to the default setting of 6:
D2(su)->set port priority fe .1.3 6
clear port priority
Use this command to reset the current CoS port priority setting to 0. This will cause all frames
received without a priority value in its header to be set to priority 0.
Syntax
clear port priority port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
port‐string Specifies the port for which to set priority. For a detailed description of
possible port‐string values, refer to “
Port String Syntax Used in the CLI ” on
page 6‐1.
priority Specifies a value of 0 to 7 to set the CoS priority for the port entered in the
port‐string. Priority value of 0 is the lowest priority.
port‐string Specifies the port for which to clear priority. For a detailed description of
possible port‐string values, refer to “
Port String Syntax Used in the CLI ” on
page 6‐1.