Enterasys Networks D-Series - Manual (Page 54)

set system enhancedbuffermode
2-16 Basic Configuration
Mode
Switch command, read‐write.
Example
This example shows how to display enhanced buffer mode status:
D2(su)->show system enhancedbuffermode enable
Optimized system buffer distribution Disable
set system enhancedbuffermode
Use this command to enable or disable enhanced buffer mode, which optimizes buffer
distribution for non‐stacking single CoS queue operation. Executing this command will reset the
switch, so the system prompts you to confirm whether you want to proceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable enhanced buffer mode:
D2(su)->set system enhancedbuffermode enable
Changes in the enhanced buffer mode will require resetting this unit.
Are you sure you want to continue? (y/n)
show time
Use this command to display the current time of day in the system clock.
Syntax
show time
Parameters
None.
Defaults
None.
enable | disable Enables or disables enhanced buffer mode.