Enterasys Networks D-Series - Manual (Page 111)

show lldp
Enterasys D-Series CLI Reference 5-15
show lldp
Use this command to display LLDP configuration information.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP configuration information.
D2(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
show lldp port status
Use this command to display the LLDP status of one or more ports. The command lists the ports
that are enabled to send and receive LLDP PDUs. Ports are enabled or disabled with the
set lldp
port status command.
Syntax
show lldp port status [port-string]
Parameters
Defaults
If port‐string is not specified, LLDP status information will be displayed for all ports.
Mode
Switch command, read‐only.
port‐string (Optional) Displays LLDP status for one or a range of ports.